Nächstes Produkt

The DIGILAB SX is a high-end prototyping system based on Altera's Stratix device family. It provides system designers with an economical solution for hardware prototyping and verification. Any Altera Stratix device in a  956 Pin BGA package is supported, from an EP1S30 all the way up to an EP1S80 with approximately 80.000 logic elements and more than 7 MBit of embedded RAM. Together with two completely independent SODIMM sockets and two general purpose prototype headers,  the DIGILAB SX can be used to setup very powerful processing and prototyping systems.

Features:

• Can be ordered with any Altera Stratix device
  in 956 Pin BGA package EP1S30, EP1S40, EP1S60 and EP1S80, any speed grade
• Optional one year Quartus II license with maintenance included
• Two independent 144-pin SODIMM sockets that can be used to connect
  • Standard SDRAM modules
  • El Camino SSRAM and FLASH modules
  • El Camino I/O and cascading modules
  • Your own custom logic extension modules
• Further interfaces
  • Two RS232 serial ports
  • Two universal prototyping headers
  • LVDS inputs/outputs
• Configuration options
  • On-board EPC16 configuration memory
  • Download cable connector
• Power supply options
  • Connector for standard PC power supply
  • Alternative, separate 5V/3.3V inputs
  • On board switching regulator for 1.5V/9W core supply
• Clock options
  • 5V crystal oscillator, exchangeable
  • Full PLL support
  • Two clock inputs, four clock outputs
• Additional features
  • Four push buttons
  • 7-segment display
  • Power-on reset logic

This picture shows the DIGILAB SX
board, equipped with a Stratix
EP1S80B956C6 device

Available Now!


pricelist

documentation (pdf, 1.260k)

The DIGILAB Memory module is a universal memory module for use with El Camino and Altera prototyping boards. It supports up to 512k x 36 synchronous SRAM as well as 2M x 16 or 4M x 8 FLASH memory, connected to a common address and data bus. The module comes in a standard 144-pin SODIMM form factor and can be used with any El Camino or Altera prototyping board that offers one or more 144-pin SODIMM sockets.
Furthermore the memory module offers all storage requirements, necessary for Cyclone based processor systems. There is an Altera EPCS4 serial configuartion device that can be used for Cyclone device configuration. A NIOS processor can use FLASH and synchronous RAM for data and program storage.

Features:

• 512k x 36 synchronous SRAM memory
• 2M x 16 or 4M x 8 FLASH memory
  • FLASH supports Byte mode
  • DQ15/A-1 pin can be disconnected from DQ bus
• All control signals available at connector for flexible use
• FLASH boot sector write protect supported with solder bridge
• Standard 144-pin SODIMM form factor
  • 31.8 mm height
• Can be used on any protoyping board with 144-pin SODIMM connector e.g. from
  • El Camino
  • Altera
• Supports Altera serial Flash EPROM
  • For Cyclone Device Configuration
  • Module identification
  • Additional memory accessible to NIOS processors

This picture shows the
DIGILAB Memory module

Available Now!

EUR    249,00 plus VAT

documentation (pdf, 311k)